Replace top air grille.
Replace the center grille louver.
Press "ACTIVATE CONTROLS" pad and close door.
NOTE: There is a 6 minute delay before the unit starts.
Using an 8" magnetic nut driver, replace
the two 1/4" screws.
Open door. Display should flash.
□ Verify cabinet size.
□ Verify electrical supply and water supply
□ Install anti-tip device(s) and verify unit is
□ Position unit in cutout, level at desired
height and secure unit.
□ Plug-in unit and verify operation.
□ Connect water supply (if applicable).
• Verify icemaker fill tube is properly
• Verify icemaker bail arm is down.
• Verify dispenser operation
□ Align/square door(s).
□ Verify drain pan is properly installed and
no leaks on water connection.
□ Install kickplate.
□ Remove internal packaging and labels
and wipe unit down.