Configuring The Switch To Access A Radius Server - HP ProCurve Switch 6120G/XG Manual

aa-bb-cc-dd-ee-ff
aa:bb:cc:dd:ee:ff
AABBCCDDEEFF
AABBCC-DDEEFF
AA-BB-CC-DD-EE-FF
AA:BB:CC:DD:EE:FF
■ If the device is a switch or other VLAN-capable device, use the base
MAC address assigned to the device, and not the MAC address
assigned to the VLAN through which the device communicates with
the authenticator switch. Note that the switch applies a single MAC
address to all VLANs configured in the switch. Thus, for a given
switch, the MAC address is the same for all VLANs configured on the
switch. (Refer to the chapter titled "Static Virtual LANs (VLANs)" in
the Advanced Traffic Management Guide for your switch.)

Configuring the Switch To Access a RADIUS Server

RADIUS Server Configuration Commands
radius-server
i
[host < p-address>]
[key < global-key-string >]
i
radius-server host < p-address> [oobm] key <server-specific key-
string> [no] radius-server host <ip-address> key
This section describes the minimal commands for configuring a RADIUS
server to support Web-Auth and MAC Auth. For information on other RADIUS
command options, refer to chapter 5, "RADIUS Authentication, Authorization,
and Accounting" .
Web and MAC Authentication
Setup Procedure for Web/MAC Authentication
below
below
3-18
3-17