Cli: Setting Passwords And Usernames - HP ProCurve Switch 6120G/XG Manual

Configuring Username and Password Security
Configuring Local Password Security
N o t e
Figure 2-3. Removing a Password and Associated Username from the Switch
2-8

CLI: Setting Passwords and Usernames

Commands Used in This Section
password See below.
Configuring Manager and Operator Passwords.
You can configure manager and operator passwords in one step. See "Saving
Security Credentials in a Config File" on page 2-10 of this guide.
Syntax: [ no ] password <manager | operator | all | port-access>
[ user-name ASCII-STR ] [<plaintext | sha1> ASCII-STR]
Figure 2-2. Example of Configuring Manager and Operator Passwords
To Remove Password Protection. Removing password protection means
to eliminate password security. This command prompts you to verify that you
want to remove one or both passwords, then clears the indicated password(s).
(This command also clears the username associated with a password you are
removing.) For example, to remove the Operator password (and username, if
assigned) from the switch, you would do the following:
The effect of executing the command in figure 2-3 is to remove password
protection from the Operator level. (This means that anyone who can access
the switch console can gain Operator access without having to enter a user-
name or password.)
• Password entries appear
as asterisks.
• You must type the
password entry twice.
Press (for yes) and press [
[Y] Enter
].