Operating Notes For Jumbo Traffic-Handling - HP ProCurve 6120G/XG Configuration Manual

Operating Notes for Jumbo Traffic-Handling

■ ProCurve does not recommend configuring a voice VLAN to accept jumbo
frames. Voice VLAN frames are typically small, and allowing a voice VLAN
to accept jumbo frame traffic can degrade the voice transmission perfor­
mance.
You can configure the default, primary, and/or (if configured) the manage­
■
ment VLAN to accept jumbo frames on all ports belonging to the VLAN.
When the switch applies the default MTU (1522-bytes) to a VLAN, all ports
■
in the VLAN can receive incoming frames of up to 1522 bytes in length.
When the switch applies the jumbo MTU (9220 bytes) to a VLAN, all ports
in that VLAN can receive incoming frames of up to 9220 bytes in length.
A port receiving frames exceeding the applicable MTU drops such frames,
causing the switch to generate an Event Log message and increment the
"Giant Rx" counter (displayed by show interfaces < port-list >).
The switch allows flow control and jumbo frame capability to co-exist on
■
a port.
The default MTU is 1522 bytes (including 4 bytes for the VLAN tag). The
■
jumbo MTU is 9220 bytes (including 4 bytes for the VLAN tag).
■ When a port is not a member of any jumbo-enabled VLAN, it drops all
jumbo traffic. If the port is receiving "excessive" inbound jumbo traffic,
the port generates an Event Log message to notify you of this condition.
This same condition generates a Fault-Finder message in the Alert log of
the switch's web browser interface, and also increments the switch's
"Giant Rx" counter.
If you do not want all ports in a given VLAN to accept jumbo frames, you
■
can consider creating one or more jumbo VLANs with a membership
comprised of only the ports you want to receive jumbo traffic. Because a
port belonging to one jumbo-enabled VLAN can receive jumbo frames
through any VLAN to which it belongs, this method enables you to include
both jumbo-enabled and non-jumbo ports within the same VLAN. For
example, suppose you wanted to allow inbound jumbo frames only on
ports 6, 7, 12, and 13. However, these ports are spread across VLAN 100
and VLAN 200, and also share these VLANs with other ports you want
excluded from jumbo traffic. A solution is to create a third VLAN with the
sole purpose of enabling jumbo traffic on the desired ports, while leaving
the other ports on the switch disabled for jumbo traffic. That is:
Ports
Jumbo-
Enabled?
VLAN 100 VLAN 200
6-10 11-15
No No
Port Traffic Controls
Jumbo Frames
VLAN 300
6, 7, 12, and 13
Yes
12-27