Using Authorized IP Managers
Defining Authorized Management Stations
Applies only to access through Telnet, SNMPv1,
and SNMPv2c. Refer to the note on page 14-3.
Figure 14-2. Example of How To Add an Authorized Manager Entry (Continued)
Editing or Deleting an Authorized Manager Entry. Go to the IP Manag
ers List screen (figure 14-1), highlight the desired entry, and press
or
CLI: Viewing and Configuring Authorized IP Managers
Authorized IP Managers Commands Used in This Section
Command
show ip authorized-managers
ip authorized-managers
Listing the Switch's Current Authorized IP Manager(s)
Use the show ip authorized-managers command to list IP stations authorized to
access the switch. For example:
14-6
2. Enter an Authorized Manager IP address here.
3. Use the default mask to allow access by one
management device, or edit the mask to allow
access by a block of management devices. See
"Building IP Masks" on page 14-10.
4. Use the Space bar to select Manager or Operator
access.
5. Press [Enter], then [S] (for Save) to configure the
IP Authorized Manager entry.
(for Delete).
[D]
<ip-address>
mask <mask-bits>
<operator | manager>
Page
below
14-7
14-8
14-8
(for Edit)
[E]