HP 1032 Manual page 4

Step Q1 Fill Out the ClusterPack Installation Worksheet
Print out this form and fill out all information for each node in your cluster.
Installation Worksheet (pdf)
Note:
You will not be able to complete the following steps if you have not
collected all of this information.
For more information, see the Comprehensive Instructions for this step.
References:
Step 1 Fill Out the ClusterPack Installation Worksheet
Back to Top
Step Q2 Install Prerequisites
Install the following software on the Management Server.
HP-UX 11i Ignite-UX
HP-UX 11i V2.0 TCOE
Install the following software on each Compute Node.
HP-UX 11i Ignite-UX
HP-UX 11i V2.0 TCOE
Allow the default choices to install.
ClusterPack requires a homogeneous operating system environment. That is, all Compute
Nodes and the Management Server must have the same release of HP-UX installed as well
as the same operating environment.
The Management Server requires at least one LAN connection. The manager must be able
to contact all the compute nodes using a "management network" that will ve configured by
Clusterpack. In addition, the management server must be able to connect to all the MP cards
on the compute nodes. No network connections need to be configured before installing
Clusterpack, the console interface can be used for all installation and configuration steps.