Basic System Operations; What Happens In An Alarm Condition; Fire Alarms; Automatic And Manual Fire Alarms - GE 4 Series User Manual

Ge user guide security systems
Hide thumbs Also See for 4 Series:
Table of Contents

Advertisement

Basic System
Operations
Note
Your system may or may not
be monitored. If it is not
monitored, no central sta-
tion reports will be made.
4
This section describes:

What Happens in an Alarm Condition

Fire and Smoke Alarms
Preventing Accidental Alarms
Arming your System
Exit and Entry Delay Times
Bypassing Sensors
Using the Chime Feature
Basic Light Control
Basic Output Control
Checking the Status of Your System
For instructions on using a phone to perform any of these functions, see "Using a Touchtone
Phone to Operate Your System".
What Happens in an Alarm Condition
Speakers and touchpads emit emergency tones.
System lights flash (requires optional equipment and programming).
Panel notifies central monitoring station for help (monitored systems only).
Pagers are notified of the event (requires optional programming).

Fire Alarms

Systems with smoke and/or heat detectors monitor for smoke and/or fire 24 hours a day in all
arming levels. During a fire alarm, system sirens sound a loud constant tone to alert you of a fire
alarm. Individual sensors also have built-in sounders to alert occupants.
You must respond quickly to fire alarms to ensure your safety and the safety of others.
To be prepared in case of a fire alarm:
Plan escape routes. Two escape routes per room are recommended.
Use a different escape route if closed doors feel warm or hot to the touch.
Emphasize that everyone should escape as quickly as possible. DO NOT gather any belong-
ings, which could delay you from getting out of the building safely.
Crawl and hold your breath as much as possible to help reduce smoke inhalation during your
escape.
Meet at a designated outdoor location.
Emphasize that no one should re-enter the building if a fire exists.
Notify the fire department from a safe location (if system is not monitored).

Automatic and Manual Fire Alarms

Automatic fire alarms occur when a smoke or heat sensor detects the threatening condition
(smoke/heat from a fire) and trips the panel, causing alarm sirens to sound. Manual fire alarms
are initiated by a person pressing the fire emergency panic buttons on a system touchpad or acti-
vating a manual pull fire device, causing alarm sirens to sound.
Note
While most alarms can be canceled or aborted to prevent reporting to the central monitoring station, fire
alarms CANNOT be aborted and are always reported. Since many communities charge for dispatching
the fire department in error, your dealer may give you specific instructions to follow in the event of an
accidental fire alarm. Record these instructions in Appendix A: User Sheets under "Accidental Smoke
and Fire Alarms".
Concord 4 Series Security Systems

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents