Steel City 20520 User Manual page 20

4. Before chuck and spindle installation, make certain
that the spindle taper (E) and the tapered hole in
the chuck (F) are clean and free of grease, lacquer,
or rust preventive coating. SEE FIG. 14, page 18.
Fig. 15
H
I
5. Open the chuck jaws completely. Make sure the
jaws are completely recessed inside the chuck.
6. Seat the chuck onto the drill press spindle as far as
it will go by placing a wooden block (G) under the
chuck (H) and tap the block up with a hammer (I).
SEE FIG. 15.
Important: DO NOT tap the chuck directly with a metal
hammer.
LAMP INSTALLATION
Fig. 16
1. Install lamp onto drill press head using two hex
socket head screws and two lock washers.
SEE FIG. 16.
NOTE: The clear plastic sleeve goes around the lamp
cord where it passes under the mounting clamps.
FASTENING DRILL PRESS
Fig. 17
G
A
To keep the drill press from tipping, sliding, or walking,
it can be fastened to the floor surface. The machine
base has two holes (A) at the center of the base where
it can be fastened to the floor. SEE FIG. 17.
20
A