Spray Arms; Waste Water Pump - Siemens SN26T592GB Operating Instructions Manual

Spray arms

Limescale and contaminants in the rinsing
water may block nozzles and bearings on
the spray arms 1: and 1J.
– Check outlet nozzles on the spray arms
for blockages.
– Unscrew the upper spray arm 1:.
– Remove the lower spray arm 1J
upwards.
– Clean spray arms under running water.
– Re-engage or screw on spray arms.
1
2

Waste water pump

Large food remnants in the rinsing water
not retained by the filters may block the
waste water pump. The rinsing water is
then not pumped out and covers the filter.
In this case:
– First disconnect the appliance from the
power supply.
– Remove the filters 1Z.
– Scoop out water, use a sponge if
required.
– Using a spoon, prise off pump cover
(as illustrated) until it clicks, then grip
the cover by the lug and first pull it
upwards until it resists and then pull it
out forwards.
– Check inner compartment and remove
any foreign objects.
– Place cover in the original position,
press down and engage.
Klick
– Install filters.
en
1
3
2
21