Additional Options; Express Wash/ Speed Perfect (Variospeed); Half Load; Hygiene - Siemens SN66M053GB Operating Instructions Manual

Additional options

* depending on model
Additional options can be set with the
buttons X.
Ÿ
Express Wash/ Speed Perfect/
E x p r e s s W a s h / S p e e d P e r f e c t ( V a r i o S p e e d )
(VarioSpeed) *
This function can reduce the running time
by approx. 20% to 50% depending on the
selected rinse programme. The change in
the running time is indicated on the digital
display h. To obtain optimum cleaning
results at a reduced running time, water
and energy consumption are increased.
§

Half load *

H a l f l o a d
If you have only a few items to wash (e.g.
glasses, cups, plates), you can switch to
"half load". This will save water, energy
and time. It is recommended to put a little
less detergent in the detergent dispenser
than for a full load.
·

Hygiene *

H y g i e n e
The temperature is increased during the
cleaning process. This increases the
hygiene status. This additional option is
ideal for cleaning e.g. chopping boards
and baby bottles.
Ï

Intensive zone *

Perfect for a mixed load. You can wash
very soiled pots and pans in the lower
basket together with normally soiled
utensils in the upper basket. The spray
pressure in the lower basket is intensified,
the rinsing temperature is increased
slightly.
¿

Extra drying *

An increased temperature during the final
rinse and an extended drying phase
ensure that even plastic parts dry better.
There is a slight increase in the energy
consumption.
I n t e n s i v e z o n e
E x t r a d r y i n g

Washing the dishes

Programme data

The programme data (consumption
values) can be found in the summary of
instructions. They refer to normal
conditions and the water hardness set
value : . Different influencing factors
such as e.g. water temperature or line
pressure may result in deviations.
A qua sensor *
A q u a s e n s o r
* depending on model
The Aqua sensor is an optical measuring
device (light barrier) which measures the
turbidity of the rinsing water.
The Aqua sensor is used according to the
programme. If the Aqua sensor is active,
"clean" rinsing water can be transferred to
the next rinse bath and water consumption
can be reduced by 3–6 litres. If the
turbidity is greater, the water is drained
and is replaced with fresh water. In the
automatic programmes the temperature
and running time can also be adjusted to
the degree of soiling.

Switching on the appliance

– Turn on the tap fully.
– Open the door.
– Switch on ON/OFF switch (.
The display of the last selected
programme flashes. This programme
remains selected if no other
programme button 0 is pressed. The
expected programme duration flashes
on the digital display h.
– Press the START button `.
– Close the door.
The programme starts running.
en
17