HP Codemaster 100 User Manual page 82

Configuring the 12-Lead Option
3
Enter the name, primary and alternate telephone numbers, receiver type, and
speed. Press or
Note that the modem ignores spaces and hyphens in the telephone number. Use
the following special symbols to specify how you want the modem to dial the
telephone number:
• comma(,): causes the modem to pause for two seconds before continuing to
dial.
• W: causes the modem to wait for a second dial tone before continuing to dial.
Use this symbol if you have to dial 9, wait for a dial tone, and then dial the
telephone number to place a call outside your house telephone system.
• P: indicates pulse dialing (with a rotary dial), instead of tone (with a keypad).
For example, if you are using a pulse telephone with your modem, and your
house telephone system requires dialing a 9 before placing an outside call, you
would enter the telephone number as:
4 Select the transmission type by pressing F3 until the appropriate transmission
type appears. The transmission type will cycle through Receiving Sta-
tion, Fax, TraceMaster A/B, PageWriter XLi, Page-
Writer 200/300, Other SCP-HP1, Other DT, Event
Summary. Event Summary is the only transmission type displayed if con-
figuring entries 10-18 (Screen 2 of 2).
5 Select the transmission speed for your transmission type by pressing F3 until
the appropriate transmission speed appears. The following table shows the rec-
ommended transmission speed for each type of transmission. Your equipment
may require a different speed.
2-28
to move the cursor to a blank field line.
P9W5553334444