$FHU 6OLP
Common Problems & Solutions
PROBLEMS
NO POWER
NO PICTURE
TRAPEZOID IMAGE ON
THE SCREEN
POOR COLOR
BLURRED IMAGE
REMOTE CONTROL
DOES NOT WORK
TRY THESE SOLUTIONS
•
Plug the power cord into the AC inlet.
•
Plug the power cord into the power inlet.
•
Wait two minutes after the projector is turned off before
turning the projector back on.
•
Check for the proper input source.
•
Ensure all cables are connected properly.
•
Adjust the brightness and contrast.
•
Remove the lens cap.
•
Reposition the unit to improve its angle on the screen.
•
Use the Keystone correction key on the control panel of
the projector or the remote control unit.
•
Select the correct video system.
•
Adjust brightness, contrast, or saturation.
•
Press Auto on the control panel of the projector or the
remote control unit to get better picture quality.
•
Adjust the
focus.
•
Reposition the unit to improve its screen angle.
•
Ensure the distance between the unit and screen is
within the adjustment range of the lens.
•
Replace the battery with a new one.
•
Make sure there is no obstacle between the remote
control and the unit.
•
Stand within 4 meters (13 feet) of the unit.
•
Make sure nothing blocks the receiver on the control
pad.