Example: F830 = 2 (Instance 100/150) - Toshiba DEV002Z Installation And Operation Manual

Example: F830 = 2 (Instance 100/150)

Byte Bit7
0 DC Braking
Command
1
Link
2
3
1 – Drive Reference Speed command value.
Frequency is specified in Hex notation with a resolution of of 0.01 Hz per unit.
Example: Set the frequency to 60 Hz. With the incremental frequency of 0.01 Hz per unit, the
corresponding entry is calculated as:
60 Hz ÷ 0.01 Hz/unit = 6000 units, or 0x1770 (Hex).
Byte Bit7
0 DC Braking
1 (Reserved)
2
3
Byte Bit Specifications
Preset Speed #1 1
0 0
Preset Speed #2 1
0 1
Preset Speed #3 1
0 2
Preset Speed #4 1
0 3
Motor #1/#2
0 4
(THR2 Selection)
0 5 PI Control
Acceleration/
0 6 Deceleration #1/#2
Selection
12
Table 4. Output Instance 100 Format.
Bit6 Bit5
Acc/Dec
PI Control
#1/#2
Frequency
Reset Trip
Link
Drive Reference Speed Hz (Low byte)
Drive Reference Speed Hz (High byte)
Table 5. Output Instance 150 Format.
Bit6 Bit5
Acc/Dec
PI Control
#1/#2
Ready Ready
without with
ST/Run ST/Run
Table 6. Data Composition of Output Instance 100.
0
Preset Speed: 0000 = Off
Preset Speed 0001 to 1111 = #1– #15
Motor #1
(THR1)
Normal Operation
Acceleration/
Deceleration #1
(AD1)
Bit4 Bit3
Preset Speed
Motor #1/#2
4
Emergency Coast to Stop
Off (ST)
Bit4 Bit3
Motor #1/#2 (Reserved)
Emergency Coast to Stop
Off (ST)
Drive Speed Hz (Low byte)
Drive Speed Hz (High byte)
1
Motor #2
(THR2)
PI Control Off
Acceleration/
Deceleration #2
(AD2)
DeviceNet Module Installation and Operation Manual
Bit2 Bit1
Preset Speed Preset Speed
3 2
Forward/
Run/Stop
Reverse
1
1
Bit2 Bit1
Alarm
Fault
(FC91)
Forward/
Run/Stop
Reverse
Supplement
The combination of 4 bits is used to
select a Preset Speed from: speed
operation Off, and Preset Speeds #1 to
#15.
Used to select a motor electronic-
thermal protection level
0: Protection Level #1 (F600)
1: Protection Level #2 (F173)
-
Used to select Acceleration/
Deceleration time
0: F009, F010
1: F500, F501
Bit0
Preset Speed
1
Jog
Bit0
Fault FL
Jog