Power Connector Cable - HP Pavilion 14 Maintenance And Service Manual

5. Remove the TouchPad button board (4).
Reverse this procedure to install the TouchPad button board.

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Optical drive (see
b.
Hard drive (see
c.
Keyboard (see
d.
Top cover (see
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Release the power connector cable from the clip (2) built into the base enclosure.
Battery on page 37), and then remove the following components:
Optical drive on page
Hard drive on page 40)
Keyboard on page 46)
Top cover on page 49)
38)
Component replacement procedures
Spare part number
722907-001
55