Replacing The Led Panel Module - Lenovo 10142/F0A9 Maintenance Manual

Step 9. Reattach the rear cover and secure it with the screws.

Replacing the LED panel module

Note: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the rear cover.
To replace the LED panel module:
Step 1. Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right view"
and "Rear view" for help with locating the various connectors.
Step 4. Remove the rear cover. Refer to "Removing the rear cover".
Step 5. Remove the converter board and cables. Refer to "Replacing the converter board".
Step 6. Remove the camera and housing. Refer to "Replacing the camera".
Step 7. Remove the tape that secures the LVDS cable to the connector.
Step 8. Press the pins to unlock the LVDS cable from the connector on the LED panel , then pull it out.
Step 9. The LED panel module including: LED panelGlassFront bezelTouch control board
Step 10. Remove the four screws that secure the front bezel hinge, then lift up the front bezel hinge to
1
remove it.
.
Chapter 8 Replacing hardware
45