Choosing The Reverb And The Chorus - Korg SP-300 User Manual

Hide thumbs Also See for SP-300:
Table of Contents

Advertisement

Available languages

Available languages

Note: When selecting the Layer mode, the total number of voices that can play at
the same time is reduced, depending on the total number of oscillators used by the
selected sounds.
Note: You can't select two sounds included under the same button.
Press one of the sound selection buttons in order to select the first sound. The LED
1
on the button you pressed will light. Use the BANK button to select a sound in one
of the other banks.
Press another sound selection button to select the second sound. The LED on the
2
button you pressed will light. Use the BANK button to select a sound in one of the
other banks.
Press both buttons at the same time to select the sounds. Both LEDs will light.
3
Note: Steps 1 and 2 are not required, if the right banks are already selected.
Returning to the Single mode.
sound selection button.
Adjusting the volume of sounds in Layer mode.
between the sounds in Layer mode, hold down the button of the sound whose level
you wish to decrease, and repeatedly press the button of the sound whose level you
wish to raise.
Note: This setting will be memorized even after turning the Layer mode off, but
will be lost when turning the instrument off. To save these settings, save them using
the Data Dump function (see "MIDI Data Dump" on page 30).

Choosing the reverb and the chorus

The SP-300 has two effects: reverb and chorus. The reverb simulates the sound
reverberation in a room, while the chorus simulates a modulating effect that makes
the sounds richer. The effect settings will be remembered even when selecting a dif-
ferent sound.
Note: Effect settings made in Single mode are memorized even when selecting the
Layer mode, but no change made in Layer mode will be preserved.
When the instrument is turned on, the effect settings are reset to the factory settings.
To save these settings, save them using the Data Dump function (see "MIDI Data
Dump" on page 30).
Basic functions
To return to the Single mode, just press a single
To
adjust
the
balance
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents