Bosch Conettix D6600 Installation And Operation Manual page 81

Conettix Communications Receiver/
Gateway
FCC Registration
Ringer Equivalence
Industry Canada
Ringer Equivalence
Display
Bosch Security Systems, Inc.
D6600 ESVUSA-25328-AL-N
D6100IPv6 ESVAL04BD6100
The D6600 Receiver is Federal Communications Commission (FCC) registered under
Part No. 68 using the RJ11C Interconnect that can be ordered from your local
telephone company.
Notice! This equipment has been tested and found to comply with the limits for a
Class A (D6600) or Class B (D6100IPv6) digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
– Any modifications made to this device that are not approved by Bosch Security
Systems, Inc. may void the authority granted to the user by the FCC to operate
this equipment.
0.4 B
D6600 1249A-8925A
D6100IPv6 1249A-6100
This product meets the applicable Industry Canada technical specifications.
The Ringer Equivalence Number is an indication of the maximum number of devices
allowed to be connected to a telephone interface. The termination on an interface
may consist of any combination of devices subject only to the requirement that the
sum of the RENs of all the devices does not exceed five (5.0).
0.2
Screen size: 0.7 in x 6.0 in (1.8 cm x 15.2 cm) dot matrix LCD (5 x 7 dots per
(H x W) character).
Shows two separate lines of 40-characters each.
LED LED display section indicates receiver status and power.
Installation and Operation Guide
Specifications | en 81
2012.11 | 08 | 4998122704