Bosch Conettix D6600 Installation And Operation Manual page 21

Conettix Communications Receiver/
Gateway
Installing Terminator Cards
Refer to D6640/D6641 Line Cards and D6645 Line Terminator Cards, page 19 when performing
the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
Notice!
i
Even if you are replacing an existing terminator card, you must proceed to Installing Line
Cards.
Figure 6.3: Removing and Installing the Terminator Card
Callout ᅳ Description
1 ᅳ Terminator Card (D6645 shown)
2 ᅳ Bracket screws (top and bottom)
3 ᅳ Empty slot
4 ᅳ D6600 chassis
Installing Line Cards
1.
Bosch Security Systems, Inc.
Remove the two bracket screws that secure the terminator card (or card slot cover, if this
is a new terminator card installation) to the back of the D6600 chassis.
If you are removing an existing terminator card, open the display door on the front of the
D6600 and pull the line card slightly out, then re-insert. This will push the existing
terminator card out the back of the D6600 chassis.
Remove the existing terminator card. Insert the new terminator card in the same slot by
aligning the top and bottom of the terminator card with the card guides in the D6600
chassis.
Slide the card into the D6600 chassis, wiggling the card as you push until the card is flush
with the back of the chassis.
Secure the bracket screws at the top and bottom of the terminator card. Ensure that the
screws are tight.
Repeat this process for all additional terminator cards.
Connect appropriate telephone line cords to the telephone line jack on the terminator
cards.
Continue to Installing Line Cards, page 21.
Install the terminator card(s) (Refer to Installing Terminator Cards, page 21).
Installation and Operation Guide
D6600 Specific Cards | en
2012.11 | 08 | 4998122704
21