Carpet Cleaning - Bissell 17N4P Series User Manual

Portable deep cleaner
Table of Contents

Advertisement

Operations

carpet cleaning

1. Plug into a proper outlet and push the on/off
button located on the front of
the handle.
2. Recline the handle by pressing on the lever
at the back of the machine behind the 2-in-1
water tank.
3. Cleaning strokes. While pressing the trigger,
make one slow forward wet pass and another
one back. Caution: Do not overwet. Take care
not to run over loose objects or edges of area
rugs. stalling brush may result in premature
belt failure.
notE: your machine is equipped with a circuit
breaker that will automatically shut off the
brush if a large or loose object is caught in the
brush roll. If that happens, be sure to unplug
your machine, remove the foreign object, and
then plug the machine back in to reset the
circuit breaker.
4. Release the trigger and make one slow
forward and backward pass over the same area
to remove any residual dirty water and aid in
drying. Repeat cleaning passes until solution
being pulled up appears clean. Continue
passes without pressing the trigger until you
can't see any more water being pulled up.
cleanShot® (select models)
Cleanshot is an optional feature that can be
used to fight tough stains. it can be used as
either a tough stain pre-treater or can be used
during the deep cleaning process itself. To use
Cleanshot either as a pre-treat, or during deep
cleaning, follow the instructions below.
1. Press the Cleanshot button on the front of
the machine's handle and aim the focused
stream onto the stain for up to 5 seconds.
2. Allow the formula to soak in for 15 seconds.
3. Run the machine over the stain to extract
until no formula or water can be seen coming
up from the carpet.
4. Repeat as needed until the stain is gone.
www.bissell.com
8
1.
1.
800.237.7691
2.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents