GE EDW4000 Technical Service Manual page 10

LOCK You can lock the controls to prevent any selections from being made. Or you can lock the
controls after you have started a cycle.
Children cannot accidentally start dishwasher by touching pads with this option
selected.
To unlock the dishwasher controls, press and hold the HEATED DRY pad for 3 seconds. To lock
the dishwasher, press and hold the HEATED DRY pad for 3 seconds. The light above the LOCK
pad will turn off.
EXTRA When selected, the NORMAL WASH cycle will run longer with heating elements on to
HOT WASH improve both wash and dry performance. NOTE: Cannot be selected with RINSE ONLY cycle.
DELAY HOURS You can delay the start of a wash cycle for up to 8 hours (on some models). Press the DELAY
HOURS pad to choose the number of hours you want to delay the start of the cycle, then press
START/RESET . The machine will count down and start automatically at the correct time.
Pressing START/RESET a second time will cancel the DELAY START selection.
NOTE: If you forget to fully close the door a reminder signal will beep until you do so.
RESET To change a cycle after washing starts, touch the START/RESET pad to cancel the cycle.
The START/RESET light will flash while the water is pumped out if needed. This takes
approximately 90 seconds. When the light stops flashing, the dishwasher can be reprogrammed
and restarted.
Start
4
Close the dishwasher door and select the
cycle and desired enhancements. Touch the
START/RESET pad to begin the cycle. Water fill
begins, and approximately 60 seconds later the
wash action begins.
NOTE: The dishwasher remembers your last cycle so
you don't have to reprogram each time. When the
dishwasher door is fully closed, the control panel
lights will display the last settings you selected.
Clean
5
The CLEAN light is illuminated when a wash cycle is
complete. The light will stay ON until the door is
opened.
Status Indicator Lights
START/RESET
CLEAN
What It Means
Cycle has been interrupted by pressing the START/RESET keypad. Light will quit
flashing after the dishwasher automatically drains out the water.
Unit has no water. Check the water supply. If water is turned on call for service.
– 8 –
If you don't want to change any of the settings,
simply touch the START/RESET pad to begin the
cycle.
If the door is closed the indicator lights will turn off
if the START/RESET pad is not selected within two
minutes. To activate the display, open and close the
door or press any pad.
Also, if a power failure occurs, NORMAL and HEATED
DRY will automatically be programmed. Make any
new selections and touch the START/RESET pad to
begin the cycle.