Water Inlet / Discharge System – Removal
The Water Level Switch and Diaphragm are
replace as one assembly. To replace, bend the
small retaining tab out away from the assembly.
To replace either Drain Hose, first remove the
Drain Hose retaining clip.
Then remove the wiring connector and slide the
assembly up and out from the Water Level Housing.
The Float Switch, item 1, is a press fit and easily
removed as an individual component.
Then bring the hose down and out from the Water
Chamber. When re-installing make sure the hose is
snug, and the retaining clip is back in place.