Hazard Flasher Switch - Ford Villager Owner's Manual

Hide thumbs Also See for Villager:
Table of Contents

Advertisement

To activate the rear washer, press the RR WASH switch. For a
constant spray, hold the switch for a few seconds. For less
washer fluid, press the switch once and release it. When you
activate the washer, the wiper will cycle twice and then stop.
Do not activate the washer for longer than fifteen seconds
continuously. This could damage the washer pump system.

Hazard Flasher Switch

The hazard flasher is used to alert other drivers to hazardous
situations.
The hazard flasher switch operates the same lamps as the turn
signal lever. When the hazard flasher is activated, all of these
lamps will flash on and off. The turn signal indicators cannot be
used when the hazard lamps are flashing. Operation of the
hazard flashers does not affect operation of the brakelamps.
The flashers work even with the key out of the ignition. The
flashers will work for up to two hours when the battery is fully
charged and in good condition. They will not drain the battery
excessively. If the flashers run for longer than two hours or if
your battery is not fully charged, your battery may be drained
to the point where the vehicle will not start.
The hazard flasher switch is located on the instrument panel to
the right of the instrument cluster.
To use the hazard flasher:
Push the HAZARD switch; you will see the turn signal
1.
arrows flash.
To stop the hazard flashers, push the HAZARD switch again.
2.
112

Advertisement

Table of Contents
loading

Table of Contents