Setting The Maximum Number Of Secure Mac Addresses - 3Com 4500G Family Configuration Manual

To do...
Enable port security
Note that:
1) Enabling port security resets the following configurations on a port to the bracketed defaults. Then,
values of these configurations cannot be changed manually; the system will adjust them based on
the port security mode automatically:
802.1X (disabled), port access control method (macbased), and port access control mode (auto)
MAC authentication (disabled)
2) Disabling port security resets the following configurations on a port to the bracketed defaults:
Port security mode (noRestrictions)
802.1X (disabled), port access control method (macbased), and port access control mode (auto)
MAC authentication (disabled)
3) Port security cannot be disabled if there is any user present on a port.
For detailed 802.1X configuration, refer to 802.1X Configuration in the Security Volume.
For detailed MAC-based authentication configuration, refer to MAC Authentication Configuration in
the Security Volume.

Setting the Maximum Number of Secure MAC Addresses

With port security enabled, more than one authenticated user is allowed on a port. The number of
authenticated users allowed, however, cannot exceed the specified upper limit.
By setting the maximum number of secure MAC addresses allowed on a port, you can:
Control the maximum number of users who are allowed to access the network through the port.
Control the number of secure MAC addresses that can be added with port security.
Follow these steps to set the maximum number of secure MAC addresses allowed on a port:
To do...
Enter system view
Enter Ethernet port view
Set the maximum number of
secure MAC addresses allowed on
a port
This configuration is different from that of the maximum number of MAC addresses that can be leaned
by the port in MAC address management.
Use the command...
port-security enable
Use the command...
system-view
interface interface-type
interface-number
port-security max-mac-count
count-value
1-6
Remarks
Required
Disabled by default
Remarks
—
—
Required
Not limited by default