3Com 4500G Family Configuration Manual page 577

To do...
Place the local user to the state of
active or blocked
Set the maximum number of user
connections using the local user
account
Specify the service types for the local
user
Configure the binding attributes for the
local user
Configure the authorization attributes
for the local user
Set the expiration time of the user
Specify the user group for the local
user
Note that:
With the local-user password-display-mode cipher-force command configured, a local user
password is always displayed in cipher text, regardless of the configuration of the password
command. In this case, if you use the save command to save the configuration, all existing local
user passwords will still be displayed in cipher text after the device restarts, even if you restore the
display mode to auto.
The access-limit command configured for a local user takes effect only when local accounting is
used.
Local authentication checks the service types of a local user. If the service types are not available,
the user cannot pass authentication.
In the authentication method that requires the username and password, including local
authentication, RADIUS authentication and HWTACACS authentication, the commands that a
login user can use after logging in depend on the level of the user. In other authentication methods,
which commands are available depends on the level of the user interface. For an SSH user using
public key authentication, the commands that can be used depend on the level configured on the
Use the command...
state { active | block }
access-limit max-user-number
service-type { ftp | lan-access |
{ ssh | telnet | terminal } * }
bind-attribute { call-number
call-number [ : subcall-number ] | ip
ip-address | location port
slot-number subslot-number
port-number | mac mac-address |
vlan vlan-id } *
authorization-attribute { acl
acl-number | callback-number
callback-number | idle-cut minute |
level level | user-profile
profile-name | vlan vlan-id |
work-directory directory-name } *
expiration-date time
group group-name
1-20
Remarks
Optional
When created, a local user
is in the state of active by
default, and the user can
request network services.
Optional
By default, there is no limit on
the maximum number of user
connections using the same
local user account.
Required
By default, no service is
authorized to a user.
Optional
By default, no binding attribute
is configured for a local user.
Optional
By default, no authorization
attribute is configured for a
local user.
Optional
Not set by default
Optional
By default, a local user
belongs to default user group
system.