Configuring MLD queries and responses in a VLAN
Follow these steps to configure MLD queries and responses in a VLAN
To do...
Enter system view
Enter VLAN view
Configure MLD query interval
Configure the maximum
response time for MLD general
queries
Configure the MLD
last-member query interval
Make sure that the MLD query interval is greater than the maximum response time for MLD general
queries; otherwise undesired deletion of IPv6 multicast members may occur.
Configuring Source IPv6 Addresses of MLD Queries
This configuration allows you to change the source IPv6 address of MLD queries.
Follow these steps to configure source IPv6 addresses of MLD queries:
To do...
Enter system view
Enter VLAN view
Configure the source IPv6
address of MLD general
queries
Configure the source IPv6
address of MLD
multicast-address-specific
queries
The source IPv6 address of MLD query messages may affect MLD querier election within the segment.
Use the command...
system-view
vlan vlan-id
mld-snooping query-interval
interval
mld-snooping
max-response-time interval
mld-snooping
last-listener-query-interval
interval
Use the command...
system-view
vlan vlan-id
mld-snooping general-query
source-ip { current-interface |
ipv6-address }
mld-snooping special-query
source-ip { current-interface |
ipv6-address }
1-13
Remarks
—
—
Optional
125 seconds by default
Optional
10 seconds by default
Optional
1 second by default
Remarks
—
—
Optional
FE80::02FF:FFFF:FE00:0001
by default
Optional
FE80::02FF:FFFF:FE00:0001
by default