Configuring Destination Multicast Mac Address For Bpdus; Bpdu Tunneling Configuration Examples; Bpdu Tunneling For Stp Configuration Example - 3Com 4500G Family Configuration Manual

To do...
Enter system view
Enter Layer 2 aggregate
interface view
Enable BPDU tunneling for a
protocol on the Layer 2
aggregate interface

Configuring Destination Multicast MAC Address for BPDUs

By default, the destination multicast MAC address for BPDUs is 0x010F-E200-0003. You can change it
to 0x0100-0CCD-CDD0, 0x0100-0CCD-CDD1 or 0x0100-0CCD-CDD2 through the following
configuration.
Follow these steps to configure destination multicast MAC address for BPDUs:
To do...
Enter system view
Configure the destination
multicast MAC address for
BPDUs
For BPDUs to be recognized, the destination multicast MAC addresses configured for BPDU tunneling
must be the same on the edge devices on the service provider network.

BPDU Tunneling Configuration Examples

BPDU Tunneling for STP Configuration Example

Network requirements
As shown in Figure
CE 1 and CE 2 are edges devices on the geographically dispersed network of User A; PE 1 and PE
2 are edge devices on the service provider network.
All ports that connect service provider devices and customer devices are access ports and belong
to VLAN 2; all ports that interconnect service provider devices are trunk ports and allow packets of
any VLAN to pass through.
MSTP is enabled on User A's network.
It is required that, after the configuration, CE 1 and CE 2 implement consistent spanning tree calculation
across the service provider network, and that the destination multicast MAC address carried in BPDUs
be 0x0100-0CCD-CDD0.
Use the command...
system-view
interface bridge-aggregation
interface-number
bpdu-tunnel dot1q { cdp |
gvrp | hgmp | pvst | stp | vtp }
Use the command...
system-view
bpdu-tunnel tunnel-dmac
mac-address
1-3:
—
—
Required
By default, BPDU tunneling for
a protocol is disabled.
—
Optional
0x010F-E200-0003 by default.
1-5
Remarks
Remarks