Configuring Information Center; Information Center Configuration Task List; Outputting System Information To The Console - 3Com 4500G Family Configuration Manual

If the timestamp starts with a %, the information is log information
If the timestamp starts with a #, the information is trap information
If the timestamp starts with a *, the information is debugging information
source
This field indicates the source of the information, such as the source IP address of the log sender. This
field is optional and is displayed only when the output destination is the log host.
content
This field provides the content of the system information.

Configuring Information Center

Information Center Configuration Task List

Complete the following tasks to configure information center:

Outputting System Information to the Console

Outputting System Information to a Monitor Terminal
Outputting System Information to a Log Host
Outputting System Information to the Trap Buffer
Outputting System Information to the Log Buffer
Outputting System Information to the SNMP Module
Configuring Synchronous Information Output
Outputting System Information to the Console
Outputting system information to the console
To do...
Enter system view
Enable information center
Name the channel with a
specified channel number
Configure the channel through
which system information can
be output to the console
Task
Use the command...
system-view
info-center enable
info-center channel
channel-number name
channel-name
info-center console channel
{ channel-number |
channel-name }
1-6
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
—
Optional
Enabled by default
Optional
Refer to Table 1-2 for default
channel names.
Optional
By default, system information
is output to the console through
channel 0 (known as console).