Configuring Wireless Lan Services - HP 5400 zl Installation And Getting Started Manual

Getting Started With Switch Configuration
Configuring the HP Wireless Edge Services zl Modules (J9051A, J9052A)

Configuring Wireless LAN Services

To configure wireless LAN services on a wireless services-enabled zl switch,
use one of the following management interfaces for the module:
■
■
The Web browser interface simplifies both management and configuration
tasks, and is recommended in most instances.
3-10
Web browser interface — Accessed through a Web browser, this
intuitive interface provides comprehensive information to help you
manage and monitor your company's wireless services. The menus
and online help guide you through configuration steps. See the HP
Wireless Edge Services zl Modules Management and Configuration
Guide for information on using the Web browser interface to
configure and manage a module.
To run the Web browser interface for the HP Wireless Edge Services zl
Module, your workstation must be running Java Virtual Machine (JVM).
If your workstation is not running the JVM and you attempt to open the
module's Web browser interface, the workstation will automatically try to
access the Internet and download the JVM.
Command line interface (CLI) — Available through a serial, Telnet, or
Secure Shell (SSH) session to the zl switch, the wireless-services
context, accessed from the zl switch's CLI config context, provides a
complete set of commands to configure, manage, and troubleshoot
your wireless services.
The CLI commands available in the wireless-services context of the zl
switch CLI are documented in an appendix of the HP Wireless Edge
Services zl Modules Management and Configuration Guide. Refer to this
manual for more information.