Horizontal Surface Mounting; Install The Grounding Wire - HP 5400 zl Installation And Getting Started Manual

4.
install and tighten the
other 12-24 screws
Figure 2-10. Screws in bracket being installed

Horizontal Surface Mounting

Place the switch on a table or other horizontal surface. Use a sturdy surface
in an uncluttered area. You may want to secure the networking cables and
switch power cord to the table legs or other part of the surface structure to
help prevent people from tripping over the cords.
N o t e
Ensure the air flow is not restricted around the sides and back of the switch.

6. Install the Grounding Wire

If a grounding wire is to be attached to the switch chassis, the grounding lug
must be removed and a wire crimped to it and the grounding lug must be
reinstalled.
1.
Install the other screw into the upper hole in each bracket. Tighten these
screws.
Use a #1 Phillips (cross-head) screwdriver and remove the grounding lug
and two screws from the back of the switch.
Installing the HP 5400 zl Switches
Installation Procedures
2-17