Filling In Fingers Captured In A Scanned Image (When A Book Is Scanned) - Fujitsu ScanSnap SV600 Basic Operation Manual

Filling in Fingers Captured in a Scanned Image (When a Book Is
Scanned)
Fingers that are captured when a book is scanned can be filled in.
ATTENTION
l To fill in fingers captured in the scanned image, the fingers need to be detected.
If a book is scanned in the following ways, captured fingers may not be detected correctly.
- When two or more fingers that are used to hold down a book to be scanned are touching each
other (Figure 1)
- When you hold down a book to be scanned with manicured fingers or fingers with artificial nails
(Figure 2)
- When you hold down a book to be scanned with your fingers bent (Figure 3)
- When fingers that are used to hold down a book to be scanned are captured 1 cm (0.39 in.) or
more (Figure 4)
- When there is text or an image within 5 mm (0.2 in.) around the fingers that are used to hold
down a book to be scanned (Figure 5)
- When a book that has a background color other than white (such as a comic magazine) is
scanned (Figure 6)
- When a book is scanned after [Gray] or [B&W] is selected from the [Color mode] drop-down list
in the [Scanning] tab of the ScanSnap setup window
1 2
l Follow the procedure below to perform multiple book image correction for one page.
1. Edit in book image correction mode (
- Correcting a distorted book image
- Splitting a double-page spread image
2. Edit in point retouch mode (
- Filling in the captured fingers in image
3 4
1 cm (0.39 in.) 5 mm (0.2 in.)
or More
).
).
80
Scanning Books
5 6
or Less