Table of Contents
Advertisement
Connecting example: AV equipment
Attention
z Always use one of the following when connecting a VCR.
– A VCR with built-in time base corrector (TBC)
– A time base corrector (TBC) between the projector and the VCR
z If nonstandard burst signals are connected, the image may be distorted. In such case, connect the time base
corrector (TBC) between the projector.
Note
z The <DVI-D IN> terminal can be used to connect the projector with an HDMI- or DVI-D compliant device.
However, with some devices the images may not appear. (
z To connect an HDMI compatible device, an HDMI-DVI-D conversion cable is required.
z When the DVI-D signal is input, EDID setting may be required depending on the connected device. (
Connecting example: Computers
Control
computer
Control
computer
Note
z The <DVI-D IN> terminal is compatible only with single link DVI signals.
z Refer to "List of compatible signals" (
projector supports.
z If you operate the projector using the computer with the resume feature (last memory), it is required to reset
the resume feature to operate the projector.
z When the SYNC ON GREEN signal is input, do not input sync signals to the <SYNC/HD> and <VD> terminals.
z When the DVI-D signal is input, EDID setting may be required depending on the connected device. (
Caution
When connecting the projector to a computer or an external device, use the power cord supplied with each
device and commercially available shielded cables.
VCR (TBC
built-in)
or
Computer
Computer
page 102) for the details of the RGB signal from the computer that the
DVD player with HDMI
terminal (HDCP)
page 58)
Computer
Connections
page 58)
page 58)
ENGLISH - 31
Advertisement
Table of Contents
