Table of Contents
Advertisement
Connections
Connections
Before connecting to the projector
z Read carefully the instruction manual for the device to be connected.
z Turning off the power switch of the devices before connecting cables.
z If any connection cable is not supplied with the device, or if no optional cable is available for the connection of
the device, prepare a necessary system connection cable to suit the device.
z Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture. In
this case, a time base corrector (TBC) must be connected.
z The projector accepts the following signals: VIDEO, S-VIDEO, analog RGB (with TTL sync. Level) and digital
signal.
z Some computer models are not compatible with the projector.
z Use a compensator when you connect each of equipment to the projector using long cables. Otherwise the
image may not be output properly.
■ <S-VIDEO IN> terminal pin assignments and signal names
Outside view
(1)
(3)
■ <RGB 2 IN> terminal pin assignments and signal names
Outside view
(11)
(15)
(6)
(1)
■ <DVI-D IN> terminal pin assignments and signal names
Outside view
(24)
(16)
(8)
30 - ENGLISH
Pin No.
(1)
(2)
(2)
(3)
(4)
(4)
Pin No.
(1)
(2)
(3)
(10)
(12)
(13)
(5)
(14)
(15)
Pin No.
(1)
(2)
(3)
(4)
(5)
(17)
(6)
(9)
(7)
(8)
(1)
(9)
(10)
(11)
(12)
Signal names
Ground (luminance signal)
Ground (color signal)
Luminance signal
Color signal
Signal names
R/PR
G/Y
B/PB
DDC data
SYNC/HD
VD
DDC clock
Signal name
T.M.D.S data 2-
T.M.D.S data 2+
T.M.D.S data 2/4
shield
–
–
DDC clock
DDC data
–
T.M.D.S data 1-
T.M.D.S data 1+
T.M.D.S data 1/3
shield
–
(4) and (9) are not used.
(5) - (8) , (10), and (11) are GND
terminals.
Pin No.
Signal names
–
(13)
+5 V
(14)
GND
(15)
Hot plug detection
(16)
T.M.D.S data 0-
(17)
T.M.D.S data 0+
(18)
T.M.D.S data 0/5
(19)
shield
–
(20)
–
(21)
T.M.D.S clock
(22)
shield
T.M.D.S clock+
(23)
T.M.D.S clock-
(24)
Advertisement
Table of Contents
