Subcommand - IBM IC35L040AVVN07-0 - 40GB IDE Deskstar 120GXP 7200RPM UATA-100 07N9682 Specifications

11.33.1 S.M.A.R.T. Subcommand
In order to select a subcommand the host must write the subcommand code to the Features Register of
the device before issuing the S.M.A.R.T. Function Set command. The subcommands and their respective
codes are listed below.
Code

Subcommand

D0h SMART Read Attribute Values
D1h SMART Read Attribute Thresholds
D2h SMART Enable/disable Attribute Autosave
D3h SMART Save Attribute Values
D4h SMART Execute Off-line Immediate
D5h SMART Read Log Sector
D6h SMART Write Log Sector
D8h SMART Enable Operations
D9h SMART Disable Operations
DAh SMART Return Status
DBh SMART Enable/Disable Automatic Off Line
11.33.1.1 SMART Read Attribute Values (Subcommand D0h)
This subcommand returns the Attribute Values of the device to the host. Upon receipt of the SMART Read
Attribute Values subcommand from the host the device saves any updated Attribute Values to the
Attribute Data sectors and then transfers the 512 bytes of Attribute Value information to the host.
11.33.1.2 SMART Read Attribute Thresholds (Subcommand D1h)
This subcommand returns the Attribute Thresholds of the device to the host. Upon receipt of the SMART
Read Attribute Thresholds subcommand from the host, the device reads the Attribute Thresholds from the
Attribute Threshold sectors and then transfers the 512 bytes of Attribute Thresholds information to the
host.
11.33.1.3 SMART Enable/Disable Attribute Autosave (Subcommand D2h)
This subcommand enables and disables the Attribute Autosave feature of the device. The SMART
Enable/Disable Attribute Autosave subcommand either allows the device to automatically save its updated
Attribute Values to the Attribute Data Sector periodically or causes the Autosave feature to be disabled.
The state of the Attribute Autosave feature (either enabled or disabled) will be preserved by the device
across power cycle.
A value of 00h written by the host into the Sector Count Register of the device before issuing the SMART
Enable/Disable Attribute Autosave subcommand will cause this feature to be disabled. Disabling this
feature does not preclude the device from saving Attribute Values to the Attribute Data sectors during
some other normal operation such as during a power-up or power-down.
A value of F1h written by the host into the Sector Count Register of the device before issuing the SMART
Enable/Disable Attribute Autosave subcommand will cause this feature to be enabled. Any other non- zero
value written by the host into this register before issuing the SMART Enable/Disable Attribute Autosave
subcommand will not change the current Autosave status but the device will respond with the error code
specified in Figure 151 on page 177.
The SMART Disable Operations subcommand disables the Autosave feature along with the SMART
operations of the device.
Deskstar 120GXP hard disk drive specifications
165