Authentication Using A Card Reader System - Xerox WorkCentre 7500 Series System Administration Manual

Security
Configuring Network Authorization
When Remotely on the Network is selected as the authorization method, the printer references an
authorization server for authorization information for the authenticated user.
®
Access Setup page, under Action, click Edit next to Authorization Server.
1. On the Xerox
2. Under Authorization Configuration, select SMB or LDAP.
3. If you select LDAP, click the link under Configuration to go to the configuration page for LDAP
Servers.
4. If you select SMB:
a. Under Configuration, type the Default Domain.
If you want to specify domain controller IP addresses or host names, select Optional
b.
Information.
c. Select IPv4 or Host Name.
d. Type the appropriately formatted address and port number. The default port number is 137.
e. Under Login Credentials to Access SMB Server, select an option:

None: The server does not require the printer to provide a user name or password.

Authenticated User: The printer uses the user name and password of the authenticated
user to access the server.

System: The printer uses the information provided in the Login Name and Password fields
to access the server.
f. If you select System, type the Login Name and Password used to access the server. Retype the
password to verify.
g. Enable Select to save new password to update the password for an existing Login Name.
5. Configure settings on the User Roles, Device Access, Service Access, and Feature Access tabs.
6. Click Apply to save the new settings or Undo to retain the previous settings.
For more information about the User Roles, Device Access, Service Access, and Feature Access tabs, see
Configuring LDAP Authorization Access

Authentication Using a Card Reader System

®
When Xerox Secure Access authentication is configured, users swipe a pre-programmed identification
card at the control panel. The printer compares the user credentials to the information stored on the
®
Xerox Secure Access server. To use Xerox
®
Unified ID System .
When Smart Card authentication is configured, users swipe a pre-programmed identification card at the
control panel. Purchase and install a Smart Card reading system before configuring Smart Card
authentication.
Before you begin:

Enable Secure HTTP (SSL). For details, see

Enable the Authentication & Authorization Configuration Web Service. For details, see
52.

Format and configure identification cards.
70 WorkCentre 7500 Series Multifunction Printer
System Administrator Guide
on page 48.
®
Secure Access, purchase and install the Xerox Secure Access
HTTP on page 52.
HTTP on page