Glass Surface - GE JGP989 Owner's Manual & Installation Instructions

Cleaning the glass cooktop.
The CERAMA BRYTE ® Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts Center.
See instructions under "To Order
Parts" section below.
NOTE: Do not use a dull or
nicked blade.
Glass surface—potential for permanent damage
Our testing shows that if
you are cooking high sugar
mixtures such as jelly or
fudge and have a spillover,
it can cause permanent
damage to the glass surface
unless the spillover is
immediately removed.
14
Heavy, Burned-On Residue
Allow the cooktop to cool.
Remove the burner grates, vent
grille and vent grille gasket.
Use a single-edge razor blade
scraper at approximately a 45°
angle against the glass surface and
scrape the soil. It will be necessary
to apply pressure to the razor
scraper in order to remove the
residue.
Metal Marks and Scratches
Be careful not to slide pots and pans
across your cooktop. It will leave metal
markings on the cooktop surface.
These marks are removable using
the CERAMA BRYTE ® Ceramic
Cooktop Cleaner with the CERAMA
BRYTE ® Cleaning Pad for Ceramic
Cooktops.
WARNING: Carefully check the bottom
of pans for roughness that would scratch
the cooktop.
Damage from Sugary Spills and Melted Plastic
Turn off all surface burners and,
with an oven mitt, remove hot
pans and grates.
Wearing an oven mitt:
a. Use a single-edge razor blade
scraper (CERAMA BRYTE
Ceramic Cooktop Scraper) to
move the spill to a cool area
on the cooktop.
b. Remove the spill with
paper towels.
To Order Parts
To order CERAMA BRYTE
Cooktop Cleaner and the cooktop
scraper, please call our toll-free number:
National Parts Center
CERAMA BRYTE ®
Ceramic Cooktop Cleaner . . . .# WX10X300
After scraping with the razor
scraper, spread a few drops of
CERAMA BRYTE
Cooktop Cleaner to the entire
burned residue area. Use the
CERAMA BRYTE
to remove any remaining residue.
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE
and a paper towel.
.
Any remaining spillover should be
left until the surface of the cooktop
has cooled.
Don't use the surface units again
until all of the residue has been
®
completely removed.
NOTE: If pitting or indentation in the glass
surface has already occurred, the cooktop
glass will have to be replaced. In this case,
service will be necessary.
® Ceramic CERAMA BRYTE
Ceramic Cooktop Scraper . .# WX10X0302
Kit . . . . . . . . . . . . . . . . . . . . . .# WB64X5027
(Kit includes cream and razor scraper)
800.626.2002
CERAMA BRYTE
Ceramic Cooktops . . . . . . . . . . .#WX10X350
®
Ceramic
® Cleaning Pad
®
Ceramic Cooktop Cleaner
®
® Cleaning Pads for