Making The Lp Conversion - GE JGP630 Installation Instructions Manual

36" sealed gas cooktop
Hide thumbs Also See for JGP630:
Table of Contents

Advertisement

Available languages

Available languages

MAKING THE LP CONVERSION

SAFETY INFORMATION YOU
1
SHOULD KNOW
The pressure regulator and burner orifices
are set for natural gas. To use Propane Gas,
the regulator and burner orifices must be
converted. The LP orifice spuds for the
cooktop burners can be located in the
literature package attached to the regulator.
CAUTION:
The cooktop, as shipped
from the factory, is set for use with natural
gas. If you wish to use your cooktop with
Liquefied Petroleum (Propane) gas, you must
first replace the orifices and convert the
pressure regulator.
WARNING:
be performed by a qualified installer or gas
supplier in accordance with the manufacturer's
instructions and all codes and requirements
of the authority having jurisdiction. Failure
to follow instructions could result in serious
injury or property damage. The qualified
agency performing this work assumes
responsibility for the conversion.
CAUTION:
The following adjustments
must be made before turning on the burner.
Failure to do so could result in serious injury.
Be sure pressure regulator has been
converted as described in Step 2.
TOOLS YOU WILL NEED
FOR LP CONVERSION
Phillips Head
Screwdriver
Pliers
Safety Glasses
Installation Instructions
This conversion must
7mm Nutdriver
No. 15 Torx-Head
Driver
Small Flat-Head
Screwdriver (4mm
or 5/32" tip size,
60mm long)
ADJUST YOUR COOKTOP FOR
2
USE WITH LP GAS
Disconnect all electrical power, at the
A
main circuit breaker or fuse box.
B
Shut off the gas supply to the cooktop
by closing the manual shut-off valve.
Adjust the pressure regulator, by the
C
following instructions:
• Unscrew the cap.
• Place your thumb against the flat side
of the spring retainer and press down
to remove the retainer.
• Carefully look at the spring retainer to
locate the NAT or LP position.
LP
NAT
LP
NAT
NAT.
Position
Pressure Regulator
• Turn the spring retainer over so that
LP is showing on the bottom.
• Snap the retainer back into position.
• Screw the cap back onto the regulator.
13
Gasket
Cap
NAT
LP
Spring
Retainer
NAT
LP
L.P./Propane
Position
OFF
FOR
DOWN

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents