Cisco 7975G Administration Manual page 74

Network Configuration Menu
Table 4-2 Network Configuration Menu Options (continued)
Option Description
Default Router 1 Default router used by the phone (Default
Router 1) and optional backup routers
Default Router 2
(Default Router 2–5).
Default Router 3
Default Router 4
Default Router 5
DNS Server 1 Primary Domain Name System (DNS)
server (DNS Server 1) and optional backup
DNS Server 2
DNS servers (DNS Server 2–5) used by the
DNS Server 3
phone.
DNS Server 4
DNS Server 5
Operational VLAN Auxiliary Virtual Local Area Network
ID (VLAN) configured on a Cisco Catalyst
switch in which the phone is a member.
If the phone has not received an auxiliary
VLAN, this option indicates the
Administrative VLAN.
If neither the auxiliary VLAN nor the
Administrative VLAN are configured, this
option is blank.
Admin. VLAN ID Auxiliary VLAN in which the phone is a
member.
Used only if the phone does not receive an
auxiliary VLAN from the switch, ignored
otherwise.
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 6.0
4-8
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
Unlock network configuration
1.
options.
Set the DHCP Enabled option
2.
to No.
Scroll to the appropriate
3.
Default Router option, press
the Edit softkey, and then
enter a new router IP address.
Press the Validate softkey.
4.
Repeat Steps 3 and 4 as needed
5.
to assign backup routers.
Press the Save softkey.
6.
1. Unlock network configuration
options.
Set the DHCP Enabled option
2.
to No.
Scroll to the appropriate DNS
3.
Server option, press the Edit
softkey, and then enter a new
DNS server IP address.
Press the Validate softkey.
4.
Repeat Steps 3 and 4 as needed
5.
to assign backup DNS servers.
Press the Save softkey.
6.
The phone obtains its Operational
VLAN ID via Cisco Discovery
Protocol (CDP) from the switch to
which the phone is attached. To
assign a VLAN ID manually, use
the Admin VLAN ID option.
Unlock network configuration
1.
options.
Scroll to the Admin. VLAN ID
2.
option, press the Edit softkey,
and then enter a new Admin
VLAN setting.
3. Press the Validate softkey and
then press the Save softkey.
OL-12642-01