Installation; Installation Installation Instructions - Beko BL 77 Manual

Table of Contents

Advertisement

3

Installation

Installation Instructions
1. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
2. If possible avoid placing the ap-
pliance near cookers, radiators or in
direct sunlight as this will cause the
compressor to run for long periods.
If installed next to a source of heat or
refrigerator, maintain the following mini-
mum side clearances:
2" (50 mm)
12" (300 mm)
From Refrigerators or Freezers
(25 mm)
3. Make sure that sufficient room is
provided around the appliance to en-
sure free air circulation. Allow a mini-
mum of 60 mm (2.4 inches) between
the top of the appliance and the ceiling
or the underside of a wall cupboard.
4. Fit the two plastic wall spacers
supplied onto the condenser at the
back of the appliance by rotating them
1/4 turn.
5. The appliance should be located on
a smooth surface.
From Cookers
From Radiators
1"
7
The two front feet can be adjusted as
required.
To ensure that,your appliance is stan-
ding upright adjust the two front feet
by turning clockwise or anti-clockwise,
until the product is in firm contact with
the floor. Correct adjustment of feet
avoids excessive vibration and noise.
6. Refer to "Cleaning and Care" secti-
on to prepare your appliance for use.
7.A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the right hand side of
the compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage. transit
.provided to avoid transit damage
EN

Advertisement

Table of Contents
loading

Table of Contents