Xerox Phaser 3610 User Manual page 118

Troubleshooting
Symptom
The printed output is foggy.
Auger marks appear on the printed
output.
The output print is wrinkled or
stained.
Envelopes are wrinkled or creased
when printed.
® ®
118 Xerox Phaser 3610 Black and White Printer
User Guide
Solutions
Clean the developer. For details, see
• To check the toner level, check the control panel, use the print driver, or
CentreWare Internet Services. If the toner cartridge is near empty,
replace it.
• Verify that the toner cartridge is approved for use in this printer, and
replace it as needed. For best results, use a genuine Xerox toner cartridge.
• Clean the developer. For details, see
• Verify that the paper is the correct size, type, and weight for the printer
and that it is loaded properly. If not, change the paper.
• Try a new ream of paper.
• Change the Paper Type settings in the print driver.
In the Printing Preferences of the print driver, on the Paper/Output tab,
change the Paper Type setting.
Check if the crease is within 30 mm (1.2 in.) of the four edges of the
envelope.
• If yes, it is printing as expected. Your printer is not faulty.
• If not, take the following actions:
Ensure that envelopes are loaded properly in the bypass tray. For details,
see Loading Envelopes in the Bypass Tray
Follow the guidelines for printing on envelopes. For details, see
for Printing Envelopes
If the problem persists, use a different size envelope.
Cleaning the Developer
Cleaning the Developer
on page 63.
on page 62.
on page 93.
on page 93.
Guidelines