Important Safety Information; For Your Safety; Proper Installation - GE 131892900 Owner's Manual & Installation Instructions

IMPORTANT SAFETY INFORMATION.

READ ALL INSTRUCTIONS BEFORE USING.
WARNING!
For your safety, the information in this manual must be followed to minimize the risk of fire
or explosion, electric shock, or to prevent property damage, personal injury, or death.
Installation and service must be performed by a qualified installer, service agency or the gas
supplier.
FOR GAS DRYERS: YOU MUST POST IN A PROMINENT LOCATION
Instructions to follow if the user smells gas: Contact your local gas
1.
supplier for information to be displayed.
Instructions concerning flammable materials as follows:
2.

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
California Safe Drinking Water and Toxic Enforcement Act
This act requires the governor of California to publish a list of substances known to the state to cause cancer,
birth defects or other reproductive harm and requires businesses to warn customers of potential exposure
to such substances.
Gas appliances can cause minor exposure to four of these substances, namely benzene, carbon monoxide,
formaldehyde and soot, caused primarily by the incomplete combustion of natural gas or LP fuels.
Properly adjusted dryers will minimize incomplete combustion. Exposure to these substances can be
minimized further by properly venting the dryer to the outdoors.

PROPER INSTALLATION

This dryer must be properly installed and located in accordance with the Installation Instructions
before it is used.
Properly ground dryer to conform with all
governing codes and ordinances. Follow details
in the Installation Instructions section.
Install or store where it will not be exposed to
temperatures below freezing or exposed to the
weather.
Connect to a properly rated, protected and sized
power supply circuit to avoid electrical overload.
Remove all sharp packing items and dispose of all
shipping materials properly.
In fulfilling the specific needs of different
commercial installations the purchaser of this
dryer may wish to locate the coin box and controls
in any of a number of locations. The
responsibility for the proper performance of this
work lies solely with the purchaser. It should be
done by properly trained and qualified
personnel, and in accordance with local code
requirements.
Any coin box or similar device added to the dryer,
either electrically or mechanically, should be
properly grounded.
Remove any accumulated time by manually
rotating timing cam in the coin box
counterclockwise until switch shuts off. Apply a
slight additional counterclockwise pressure to
further seat drive. Make certain not to turn cam
past switch shut-off position. Otherwise, one
increment of time will be gained. Switches are off
when the plastic switch actuating arm (inner) is
down and all 3 switch buttons are depressed.
Exhaust/Ducting:
This dryer MUST be exhausted to the outside.
1
Use only rigid metal or flexible metal 4
2
diameter ductwork inside the dryer cabinet or
for exhausting to the outside. USE OF PLASTIC
OR OTHER COMBUSTIBLE DUCTWORK CAN
CAUSE A FIRE. PUNCTURED DUCTWORK CAN
CAUSE A FIRE IF IT COLLAPSES OR BECOMES
OTHERWISE RESTRICTED IN USE OR DURING
INSTALLATION.
Follow details in the Installation Instructions section.
3