Table of Contents
Advertisement
Remote commands
Follow the commands below to access features when you are away
from the MFC. When you call the MFC and enter your Remote
Access Code (3 digits followed by
beeps and you must enter a remote command.
Remote commands
95
Change the Fax
Forwarding or Fax Storage
settings
1 Off
2 Fax Forwarding
4 Fax Forwarding number
6 Fax Storage
96
Retrieve a fax
2 Retrieve all faxes
3 Erase faxes from the
memory
97
Check the receiving status
1 Fax
98
Change the Receive Mode
1 External TAD
2 Fax/Tel
3 Fax Only
90
Exit
8 - 5 REMOTE FAX OPTIONS
), the system will give two short
Operation details
You can select Off after you have retrieved
or erased all your messages.
If you hear one long beep, the change has
been accepted. If you hear three short beeps,
you cannot change it because the conditions
have not been met. You can register your Fax
Forwarding number by entering 4. (See
Changing your Fax Forwarding number on
page 8-6.) Once you have registered the
number, Fax Forwarding will work.
You can select Off after you have retrieved
or erased all your messages.
Enter the number of a remote fax machine to
receive stored fax messages. (See Retrieving
fax messages on page 8-6.)
If you hear one long beep, you can erase fax
messages from the memory.
You can check whether your MFC has
received any faxes. If it has, you will hear one
long beep. If not you will hear three short
beeps.
If you hear one long beep, you can change
the Receive Mode.
After a long beep, you can exit Remote
Retrieval.
Advertisement
Table of Contents
