Care And Cleaning - GE Monogram ZDWR240 Owner's Manual

Wine reserve
Table of Contents

Advertisement

For your
safety
Cleaning
the inside
Drain hole
Cleaning
the outside
Glass door
Door gasket
Unplug the wine reserve before cleaning. If the unit is in a built-in location,
remove power at the circuit breaker.
Unplug the wine reserve before cleaning.
If the unit is in a built-in location, remove
power at the circuit breaker. Use a slightly
damp cloth or sponge when cleaning
around switches, lights or controls.
Use warm water and baking soda solution—
about a tablespoon (15 ml) of baking soda
to a quart (1 liter) of water. This both
cleans and neutralizes odors. Thoroughly
rinse and wipe dry.
Periodically check the drain hole and
channel for any debris. If the drain is
blocked, condensation will not drain
properly.
To check and clean the drain hole,
remove the third and fourth drawers
(see instructions on Removing full extension
drawers). Sweep a damp cloth along the
channel in the back of the wine reserve.
Use a finger to sweep away any debris
from the drain hole.
The exterior surfaces can be washed with
mild soap and water.
Rinse thoroughly with clear water. Never
use abrasive scouring powders.
Use a glass cleaner or mild soap and water
and a soft cloth to clean the glass door.
Do not use any abrasive powders.
The vinyl gasket may be cleaned with mild
soap and water, a baking soda solution or
a mild scouring powder. Rinse well.

Care and Cleaning

Wine Reser ve
Other parts of the wine reserve center
unit—including the door gaskets, and
full extension drawers—can be cleaned
the same way.
Drain hole
Appearance may vary
Do not use scouring pads, powdered
cleaners, bleach or cleaners containing bleach
because these products can scratch and
damage the finish.
Warranty does not cover damage due to
improper cleaning methods.
Avoid cleaning cold glass with hot water
because the extreme temperature
difference may cause it to break. Rough
handling of tempered glass can cause it
to shatter.
After cleaning the door gasket, apply a thin
layer of paraffin wax or petroleum jelly to
the door gasket at the hinge side. This
helps keep the gasket from sticking and
bending out of shape.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents