Allied Telesis CAM Quick Install Manual

Linecam content addressable memory (cam) extender cards

CAM

Quick Install Guide

Table of Contents

Need help?

Do you have a question about the CAM and is the answer not in the manual?

Page 1 Quick Install Guide...
Page 2 Allied Telesis, Inc. reserves the right to make changes in specifications and other information in this document without prior written notice. The information provided herein is subject to change without notice. In no event shall Allied Telesis, Inc. be liable for any incidental, special, indirect, or consequential damages whatsoever, including but not limited to lost profits, arising out of or related to this manual or the information contained herein, even if Allied Telesis, Inc.
Page 3: Package Contents
Unpack the CAM card in an antistatic environment. Do not attempt to install any hardware without observing correct antistatic procedures. Failure to do so may damage the switch or CAM card. If you are unsure what the correct procedures are, contact your authorised Allied Telesis distributor or reseller.
Page 4 2 screws at the rear. Align the CAM. Position the CAM card over the CAM slot on the switch’s PCB. The three support pillars located on the board should be aligned with the holes on the CAM card, and the cards chamfers should be pointing to the switch’s PSU (see Figure 1 on page 4).
Page 5 If there is no entry for the CAM, or the entry displays an unexpected value, then the switch has not correctly detected the CAM’s presence. The most likely cause is that the CAM card is not correctly plugged into the its slot. Repeat the installation process, paying particular attention to the CAM card alignment and insertion steps.

Cam series