Bowflex Xtreme 2 SE Assembly Manual page 22

step 19 Cable and Pulley
Routing – Connect Rod Cables
through the Right Floating and
Lat Tower Pulleys
Locate the following items for the Lat
Pulley Housing assembly:
• 3 & 8 Floating Pulleys (connected
unit)
• (2) Cable End Stop Balls with Core
(see Detail)
19-1
Locate the Right Rod Cable that
you ran through the Lat Pulley
Housing . Thread the Cable
through the (3) Floating Pulley,
as shown .
19-2
Continue to guide the Cable
through the (4) Pulley on the
Rear Lat Cross Bar, and then
through the (5) Pulley on the
Front Lat Cross Bar as shown.
19-3
Insert the Cable End through
the Cable End Stop Ball, and
attach the Cable Core to keep
the Cable from slipping back
through the Pulleys . See
Figure 19b .
note:
The Cable End Stop Ball Core
should fit over the Ferrue
when installed correctly .
Rotate the Core to align it
with the groove in the Ball .
18
Bowflex Xtreme 2 SE Assembly Manual
®
Assembly Guide
5
4
2
3