Settings In The Troubleshooting Menu - HP CC487-91209 Fax Manual

Fax Send settings
Fax Receive

Settings in the Troubleshooting menu

Open the Administration
Troubleshooting
54 Chapter 2 HP Color LaserJet CM3530 MFP Series
settings
menu, and then select the
menu settings
Maximum baud rate: This setting provides a list of baud rates
to select for operation. If the fax is having communication
errors, use this setting to select slower baud rates to
determine if the communication error is caused by the phone
line. First drop down to 14,400 bps, and then to 9,600 bps.
Once this setting is set, it remains set until changed.
TCF T.30 Delay Timer: This setting has a range between 60
to 255 ms. It should be left to its default value of 60 ms. Use
this setting when directed by an HP technical support agent
as adjustment procedures associated with it is beyond the
scope of this guide.
TCF Extend: This setting has a range between 0 to 2550 ms.
It should be left to its default value of 0 ms. Use this setting
when directed by an HP technical support agent as
adjustment procedures associated with it is beyond the
scope of this guide.
Ring Interval: This setting is used to adjust for some PBX
ring signals. Use this setting when directed by an
HP technical support agent.
Ring Frequency: This setting has a range between 1 to 200
Hz. It should be left at its default value of 68 Hz. Use this
setting when directed by an HP technical support agent as
adjustment procedures associated with it is beyond the
scope of this guide.
Troubleshooting menu.
Fax T.30 Trace: The Fax T.30 trace is a printed report which
produces a record of all the communications between the
sending and receiving fax machines for the last Fax
transmission or reception. The report has many technical
details which are usually beyond the scope of most users.
However the report contains detailed error codes and other
information that might be useful in troubleshooting a
particular problem related to sending or receiving a FAX. The
report contents might be requested by an HP service
representative when trying to determine the cause of a
problem and will help to determine the appropriate action.
(For error code information, see
on page 47.)
Fax V.34: This setting has two values (Normal and Off) that
control the modem's baud rate. The Normal setting allows
the modem to select (negotiate with the other modem) any of
the supported baud rates up to 33,600 bps. The Off setting
sets the baud rate to a maximum of 14,400 bps. This setting
remains set, until changed.
Fax Speaker mode: This service setting has two modes,
Normal and Diagnostic. In Normal mode, the modem
speaker is turned on during dialing through the initial
connection and then shuts off. For Diagnostic mode, the
speaker is turned on and remains on for all fax
communications until the setting is returned to Normal.
Fax error messages
ENWW