Send-Fax Messages - HP CC487-91209 Fax Manual

Send-fax messages

Table 2-1 Send-fax messages
Message
Cancelled
Success
Fail Busy
No Answer
Compression Error
No Dial
Modem Fail
Communication Error
Communication Error
Space Fail
Page Fail
Memory Error
Job Fail
Power Failure
No Fax Detected
ENWW
Error No.
0
n/a
0
0
Any
0
Any
17 or 36
Any besides 17 or 36
0
0
0
Any
0
17 or 36
Description
Fax was cancelled by user at
control panel of product.
Fax sent successfully.
The receiving fax machine is
busy.
The receiving fax machine is
not answering the call.
Fax may be corrupted or not
sent.
No dial tone is detected
when sending the fax.
Unexpected or bad response
from the internal fax modem
to product.
Lost telephone connection
between sender and
receiver.
General communications
issue where the fax
transmission was interrupted
or did not proceed as
expected.
Unable to read or write the
fax image file to disk; could
be corrupt product disk or no
space available on the
product's disk.
Incompatible page width, or
page had too many bad
lines.
Out of RAM memory on
product.
Fax failure; the fax job did
not complete.
A power failure occurred
during the fax transmission
on the sending fax product.
No fax machine was
detected at receiving end.
Action(s)
None.
None.
The fax will be retired
automatically (if configured),
otherwise try resending fax
later.
The receiving fax machine
may be disconnected or
turned off; contact the
receiver to check the
machine. Try resending.
Try resending fax.
Verify the phone line is
active; set the sending fax to
"not" to detect a dial tone.
Try resending fax; if the error
persists, contact service.
Try resending the fax.
Try resending fax; if the error
persists, contact service.
Try resending fax; if the error
persists, contact service.
Try resending fax; if the error
persists, contact service.
If error persists, may need to
add RAM to product.
Try resending fax; if the error
persists, contact service.
Try resending the fax.
Verify fax number and have
receiver verify fax machine is
on and connected; then try
resending fax.
Solve fax problems 49