Black & Decker EGBL108-XE Original Instructions Manual page 5

Health hazards caused by breathing dust developed when

using your tool (example:- working with wood, especially
oak, beech and MDF.)
Labels on tool
The following symbols are shown on the tool:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.

Do not expose the battery to water.

Do not store in locations where the temperature may

exceed 30 °C.
Charge only at ambient temperatures between 4 °C and

40 °C.
Charge only using the charger provided with the tool.

When disposing of batteries, follow the instructions given

p
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
Use your Black & Decker charger only to charge the

battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.

Have defective cords replaced immediately.

Do not expose the charger to water.

Do not open the charger.

Do not probe the charger.

$
The charger is intended for indoor use only.
Read the instruction manual before use.
(Original instructions)
#
Electrical safety
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Chuck
4. Torque adjustment collar
5. Battery
6. Bit holder
Fig. A
7. Charger
8. Charging indicator
Assembly
Warning! Before assembly, remove the battery from the tool.

tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release button (9) while at

the same time pulling the battery out of the receptacle.
Fitting and removing a drill bit or screwdriver bit
exchange of bits.
Grasp the rear half of the chuck (3) with one hand and use

your other hand to rotate the front half in the
counterclockwise direction, as viewed from the chuck end.
Insert the bit shaft (10) into the chuck.

Firmly tighten the chuck by holding the rear half of the

chuck and rotating the front portion in the clockwise
direction as viewed from the chuck end.
ENGLISH
5