Advertisement
Do not use any power adapter that shows corrosion at the ac input pins and/or shows signs of overheating (such as
deformed plastic) at the ac input or anywhere on the power adapter.
Do not use any power cords where the electrical contacts on either end show signs of corrosion or overheating or where
the power cord appears to have been damaged in any way.
Extension cords and related devices
Ensure that extension cords, surge protectors, uninterruptible power supplies, and power strips that you use are rated to
handle the electrical requirements of the product. Never overload these devices. If power strips are used, the load should
not exceed the power strip input rating. Consult an electrician for more information if you have questions about power
loads, power requirements, and input ratings.
Plugs and outlets
If a receptacle (power outlet) that you intend to use with your computer equipment appears to be damaged or corroded,
do not use the outlet until it is replaced by a qualified electrician.
Do not bend or modify the plug. If the plug is damaged, contact the manufacturer to obtain a replacement.
Some products are equipped with a three-pronged plug. This plug fits only into a grounded electrical outlet. This is a
safety feature. Do not defeat this safety feature by trying to insert it into a non-grounded outlet. If you cannot insert the
plug into the outlet, contact an electrician for an approved outlet adapter or to replace the outlet with one that enables
this safety feature. Never overload an electrical outlet. The overall system load should not exceed 80 percent of the
branch circuit rating. Consult an electrician for more information if you have questions about power loads and branch
circuit ratings.
Be sure that the power outlet you are using is properly wired, easily accessible, and located close to the equipment. Do
not fully extend power cords in a way that will stress the cords.
Connect and disconnect the equipment from the electrical outlet carefully
viii
E500 PROJECTOR
Advertisement
