Table of Contents
Advertisement
RxRDYA—Channel A Receiver Ready or FIFO Full
The function of this bit is programmed by MR1A bit 6.
1 = If programmed as receiver ready, a character has been received in channel A
and is waiting in the receiver buffer FIFO. If programmed as FIFO full, a
character has been transferred from the receiver shift register to the FIFO, and
the transfer has caused the channel A FIFO to become full (all three positions
are occupied).
0 = If programmed as receiver ready, the CPU32 has read the receiver buffer. After
this read, if more characters are still in the FIFO, the bit is set again after the
FIFO is 'popped'. If programmed as FIFO full, the CPU32 has read the receiver
buffer. If a character is waiting in the receiver shift register because the FIFO is
full, the bit will be set again when the waiting character is loaded into the FIFO.
TxRDYA—Channel A Transmitter Ready
This bit is the duplication of the TxRDY bit in SRA.
1 = The transmitter holding register is empty and ready to be loaded with a character.
This bit is set when the character is transferred to the transmitter shift register.
This bit is also set when the transmitter is first enabled. Characters loaded into
the transmitter holding register while the transmitter is disabled are not
transmitted.
0 = The transmitter holding register was loaded by the CPU32, or the transmitter is
disabled.
7.4.1.13 INTERRUPT ENABLE REGISTER (IER). The IER selects the corresponding bits
in the ISR that cause an interrupt output ( IRQ ). If one of the bits in the ISR is set and the
corresponding bit in the IER is also set, the IRQ output is asserted. If the corresponding
bit in the IER is zero, the state of the bit in the ISR has no effect on the IRQ output. The
IER does not mask the reading of the ISR. The ISR XTAL_RDY bit cannot be enabled to
generate an interrupt. This register can only be written when the serial module is enabled
(i.e., the STP bit in the MCR is cleared).
COS—Change-of-State
1 = Enable interrupt
0 = Disable interrupt
DBB—Delta Break B
1 = Enable interrupt
0 = Disable interrupt
7-34
Freescale Semiconductor, Inc.
IER
7
6
5
4
COS
DBB
RxRDYB TxRDYB
RESET:
0
0
0
0
Write Only
MC68340 USER'S MANUAL
For More Information On This Product,
Go to: www.freescale.com
$715
3
2
1
0
0
DBA
RxRDYA TxRDYA
0
0
0
0
Supervisor/User
MOTOROLA
Advertisement
Table of Contents
