Maintenance - Craftsman 25cc - Propane Curved Shaft Trimmer Powered by Lehr Operation Manual

MAINTENANCE

FREQUENCY
BEFORE STARTING ENGINE
EVERY 10 HOURS
FIRST CHANGE AT 10 HOURS
EVERY 25 HOURS THEREAFTER
E VERY 25 HOURS
EVERY 25 HOURS
Perform these required maintenance procedures at the
frequency stated in the table. These procedures should
also be a part of any seasonal tune-up.
NOTE: Failure to maintain your trimmer at the recom -
mended schedule may result in poor performance and/
or cause permanent damage to your trimmer
NOTE: Some maintenance procedures may require
special tools or skills. If you are unsure about these pro -
cedures call 1-866-941-LEHR for the location of your
nearest authorized service dealer.
NOTE: Maintenance, replacement, or repair of the
emission control devices and system may be performed
by any non-road engine repair establishment, individual
or authorized service dealer.
Oil Fill Plug/Dipstick
O-ring
Full
Add
WARNING:
WHEN SERVICING, USE ONLY
IDENTICAL REPLACEMENT PARTS. USE
OF ANY OTHER PARTS MAY CREATE A
HAZARD OR CAUSE PRODUCT
DAMAGE
WARNING:
TO PREVENT EXTENSIVE ENGINE WEAR AND
DAMGE TO THE UNIT, ALWAYS MAINTAIN THE
PROPER OIL LEVEL IN THE CRANKCASE. NEVER
OPERATE THE UNIT WITH THE LEVEL BELOW
THE BOTTOM OF THE DIPSTICK.
12
LEHR |
ALL RIGHTS RESERVED 2008-2009
MAINTENANCE REQUIRED
CHECK OIL
CLEAN AND RE-OIL AIR FILTER
CHANGE OIL
CHANGE OIL
CHECK SPARK PLUG POSITION AND GAP
R OCKER ARM CLEARANCE ADJ USTMENT
CHECKING THE OIL LEVEL
The importance of checking and maintaining the proper
oil level in the crankcase cannot be overemphasized.
Check oil before each use:
1. Stop the engine and allow to cool.
2. Place the unit on a at, level surface to get a proper
3. Keep dirt, grass clippings and other debris out of the
4. Remove the oil ll plug/dipstick and wipe o oil. Rein -
5. Remove the oil ll plug/dipstick and check the oil level.
6. If the level is low, add a small amount of oil to the oil
NOTE: Do not over ll the unit.
NOTE: Make sure the O-Ring is in place on the oil ll
plug/dipstick when checking and changing the oil
(Fig. 17).
Fig. 17
oil level reading.
engine. Clean the area around the oil ll plug/dipstick
before removing it.
sert it all the way back in.
Oil should be between the add and ll marks. (Fig. 17)
ll hole (Fig. 18) and recheck. Repeat this procedure
until the oil level reaches the full mark of the dipstick:
Oil Fill Plug/
Dipstick
Oil Fill Hole
Fig. 18
REFER TO
PAGE 6
PAGE 13
PAGE 13
PAGE 13
PAGE 14
PAGE 17